All buildings are fully guaranteed to be free from defects and faulty installation for a period of 12 months.
We
would like to remind customers that timber is an organic product,
subject to naturally occurring changes that result from different
environmental conditions i.e. changes in colour, surface, splits and
shrinkage. We cannot accept any responsibility for these natural
changes.
All base work is the responsibility of the
customer as is the safe securing of the building once erected. We
require a level solid base, either paving slabs or concrete upon which
to install your building.
Pressure treated floor
bearers laid on top of your prepared base are an important and valuable
option as they allow the circulation of air underneath the timber floor
and help to keep it dry and sound.
Please allow for as much room as possible around the building for our installers to work during installation.
Our
installers will need a clear access to carry building sections from the
vehicle to your prepared base with no height restrictions or tight
sharp corners to negotiate. Our installers cannot lift sections over
fences more than 4' in height or over buildings such as garages. If the
only access is through the house a straight run is required, many
sections will not pass through standard doorways. Please advise us in
advance if there are any difficulties regarding access.
Always make allowance for any roof overhang when buildings have to go into confined spaces.
All
of our buildings are treated with a good quality timber preservative on
the inside as well as the outside prior to leaving the factory. We
recommend that you re-treat your buildings at regular intervals to
maintain the appearance and life span of your building.
Cedar buildings are cedar clad only i.e. they have deal framing, floors, roofs and verandahs.
Ironmongery is black japanned, galvanised, brass or brass plated.
Glass is 3mm horticultural, 4mm toughened or 4mm float glass.
All roofs are protected with a layer of green or optional red mineral felt.
All timber sizes stated are finished sizes i.e. after machining, please note that finished sizes can vary by plus or minus 1mm.
All building dimensions shown in this brochure are approximate, based on external wall sizes.
All timber used in the construction of our buildings originates from sustainable forests.
Our
policy is one of continuous development and improvement, therefore we
reserve the right to change specifications and prices without notice.